Answers are grounded in this paper and cite their sources.
The microstructural evolution and mechanical properties of as-cast Si x AlCoCrFeNi 2.1 alloys with x = 0, 0.1, 0.2, and 0.3 were investigated, together with the thermomechanical response of the representative Si0.1 alloy. In the as-cast state, Si addition promotes the development and connectivity of the hard B 2 phase, changing the FCC/B 2 morphology from a fine lamellar and interpenetrating structure to a coarser, B 2 -dominated framework. As x increases to 0.3, the B 2 phase area fraction reaches 70.7%, accompanied by an increase in UTS from 1014 to 1318 MPa and in hardness from 276.7 to 450.8 HV, while ductility decreases continuously. The fracture mode correspondingly changes from ductile or mixed fracture to cleavage-dominated brittle fracture. After hot rolling at 850 °C, the as-cast duplex structure is redistributed and deformation-induced substructures are introduced. Subsequent annealing produces temperature-dependent recovery, recrystallization, phase redistribution, and coarsening. Among the investigated processed Si0.1 alloys, HRSi0.1-900 exhibits the most favorable tensile performance, with a UTS of 1299 MPa and a total elongation of 14.5%. This response is associated with partial recrystallization, retained FCC/B 2 interfaces, retained deformation substructures, and the presence of B 2 -type secondary particles. In contrast, annealing at 1050 °C is associated with pronounced ductility deterioration, extensive recrystallization, phase coarsening, and weakened interface-mediated strain accommodation. These results show that trace Si addition can tailor the FCC/B 2 phase constitution and annealing response of AlCoCrFeNi 2.1 -based eutectic high-entropy alloys when the processing condition is properly controlled.
No takes yet. Share an insight, caveat, or question.
Fan et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: