Answers are grounded in this paper and cite their sources.
According to the third theorem of similarity, a layered physical model was established using two types of materials with different shear stiffnesses. This model was used to represent the prototype in shaking table tests, and the influences of the burial depth and thickness of the hard interlayer on the amplification factor and on the characteristic parameters of the response spectrum were analysed and studied. The study revealed the following: (1) The influence trends of the burial depth and thickness of the hard interlayer on the amplification factor and on the characteristic period of the response spectrum obtained from the shaking table tests were found to be consistent with those obtained from a one-dimensional equivalent linearization calculation. This comparison serves as a verification of the experimental results rather than as an independent conclusion. (2) When the interlayer was located in the upper layer, the amplification factor gradually decreased with increasing thickness, with a maximum decrease of 6.6%. (3) When the input seismic motion was 0.1 g, the platform value of the response spectrum decreased linearly with increasing burial depth of the interlayer.(4) With increasing input seismic motion, the influence of the interlayer thickness on the characteristic period of the response spectrum remained almost unchanged when the interlayer was located at the bottom, whereas it varied considerably when the interlayer was located at the top. The results clarify the influence of the burial depth and thickness of hard interlayers on the amplification factor and on the characteristic parameters of the response spectrum, and provide a reference for the seismic response analysis and the seismic suitability evaluation of sites containing hard interlayers.
No takes yet. Share an insight, caveat, or question.
Qiao et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: