Answers are grounded in this paper and cite their sources.
The present study evaluates the technological suitability of a natural basalt raw material, designated Basalt C-1, for continuous basalt fiber production under laboratory conditions. The investigation included determination of melting behavior, temperature-dependent melt viscosity, upper crystallization temperature, melt homogenization conditions, stable drawing temperature range, melt throughput, drawing-speed effects, and selected properties of the produced fibers. The melt viscosity of Basalt C-1 ranged from approximately 6 to 52 Pa·s between 1450 and 1250 °C, while the upper crystallization temperature was approximately 1250 °C. A visually homogeneous melt was obtained at approximately 1360 °C after holding for more than 1 h. Stable continuous fiber drawing was achieved within an operating melt-temperature range of approximately 1320–1410 °C. Fibers with diameters of approximately 8–30 µm were produced, with a practical drawing-speed range of approximately 750–980 m min⁻¹ yielding fibers of approximately 8–13 µm. For fibers with a nominal diameter of about 12 µm, tensile strength was approximately 1500–2200 MPa and Young’s modulus approximately 75–82 GPa. Comparison with a reference andesite-basalt processed on the same laboratory equipment showed that Basalt C-1 exhibited lower melt viscosity and a lower operating temperature range while maintaining comparable fiber-forming capability. The results demonstrate the value of comparative laboratory testing for evaluating the technological potential of natural basalt raw materials prior to pilot-scale and industrial verification.
No takes yet. Share an insight, caveat, or question.
Aleksandr Novytskyi (2026) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: