Answers are grounded in this paper and cite their sources.
This work presents the development of Al₂O₃/A356 metal matrix composites produced by combining ceramic vat photopolymerization (VPP-UVL/C) of lattice reinforcements with vacuum-assisted metal infiltration. The feasibility of the proposed manufacturing route and the influence of reinforcement architecture on the physical and mechanical properties of the resulting composites were characterized through dimensional, gravimetric, mechanical and microstructural analyses. The results demonstrated that complex alumina lattice structures can be successfully manufactured with good dimensional fidelity and subsequently infiltrated to produce dense composites. By tailoring the lattice architecture, alumina contents ranging from approximately 15 to 42 wt.% were achieved, enabling control of composite density and reinforcement distribution. The incorporation of ceramic reinforcements increased the ultimate tensile strength (UTS) by up to 44% compared with the unreinforced A356 alloy, reaching values of 245 MPa. However, tensile strength was found to depend not only on reinforcement content but also on reinforcement architecture and matrix–reinforcement bonding. Statistical and fractographic analyses identified longitudinal strut diameter and strut spacing as the geometric parameters with the greatest influence on mechanical performance. Overall, the results demonstrate the potential of combining ceramic additive manufacturing with metal infiltration to produce architected metal matrix composites whose properties can be tailored through lattice geometry.
No takes yet. Share an insight, caveat, or question.
Rodriguez-Gonzalez et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: