Answers are grounded in this paper and cite their sources.
: Fe(iron) is beneficial in die-cast aluminum alloys, but its Fe-rich phases are highly detrimental to ductility, which limits the tolerable Fe content. In this study, a strategy of partially substituting Mn with Fe combined with Al-Sr-RE composite modification is proposed to improve the mechanical properties. Under a constant total (Mn+Fe) content, the effects of Fe content on the three-dimensional (3D) morphological evolution of Fe-rich phases and the mechanical properties of Al-7Si-0.2Mg-xFe-(0.8-x)Mn alloy were investigated using OM, SEM, EDS, DSC, and synchrotron radiation X-ray computed tomography (SRXCT). The results show that with increasing Fe content and decreasing Mn content, the morphology of the Fe-rich phases evolves: needle-like + Chinese-script → Chinese-script → needle-like + Chinese-script → coarse needle-like. When both Fe and Mn contents reach 0.40%, corresponding to an Mn/Fe ratio of approximately 1, the Fe-rich phases are dominated by fine and compact Chinese-script structures with a multi-branched polyhedral 3D morphology. At this composition, the alloy achieves the optimal mechanical properties, with a tensile strength of 176 MPa and an elongation of 9.6%, respectively. DSC results and thermodynamic calculations indicate that when the contents of Fe and Mn are close, the precipitation temperature range of the Fe-rich phases overlaps with the α-Al eutectic reaction. The competitive growth between them promotes the formation of fine and compact Fe-rich phases, which is the main reason for achieving a good combination of strength and ductility. This study provides new insight for the high-value utilization of recycled aluminum with high Fe content.
No takes yet. Share an insight, caveat, or question.
Peiyun et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: