Answers are grounded in this paper and cite their sources.
Laser-assisted ultrasonic surface rolling (LA-USR) combines localized laser heating with high-frequency mechanical rolling to modify the near-surface state of Ti-6Al-4V. This study evaluated nine processing conditions formed by laser powers of 150, 200 and 250 W and nominal rolling-depth settings of 30, 50 and 70 µm. X-ray diffraction, sin²ψ residual-stress measurements, three-dimensional areal profilometry, HV0.2 microhardness testing and an experimentally calibrated MATLAB response-surface model were used to assess the coupled response. The lowest measured surface-topography values occurred at 150W-50D, with Sa = 0.406 µm, Sq = 0.524 µm, Sdq = 0.0754 and Sdr = 0.281%. The 200W-50D condition was also smooth, whereas 250W-70D produced the most severe roughening (Sa = 3.974 µm, Sq = 9.146 µm and Sdr = 4.616%). Microhardness reached a maximum of approximately 818 HV0.2 at 250W-50D, demonstrating that maximum hardening and minimum roughness did not coincide. Residual stress was predominantly compressive but strongly reflection-dependent; for example, 200W-70D gave -164.0 and +132.2 MPa for the two evaluated reflections. The MATLAB model reproduced Sa and Sq well in calibration (R² = 0.977 and 0.974), but leave-one-condition-out performance was weaker, particularly for residual stress (LOOCV R² = -0.879). The results identify a non-monotonic thermo-mechanical process window and show that LA-USR optimization requires simultaneous consideration of surface topography, hardness, crystallographic response and residual stress.
No takes yet. Share an insight, caveat, or question.
Tahami et al. (2026) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: