Answers are grounded in this paper and cite their sources.
The incorporation of waste materials into cementitious systems has gained attention as a strategy to reduce the environmental impact of the construction industry. This study investigates the feasibility of using polyester textile waste (PTW) as a partial cement replacement in mortar. PTW was incorporated at 0.5% and 1.0% by weight of cement and compared with a control mixture. Flow table and compressive strength tests, thermogravimetric analysis (TGA), X-ray diffraction (XRD), scanning electron microscopy (SEM), and Raman spectroscopy were conducted to evaluate fresh, mechanical, and microstructural properties. Increasing PTW content reduced both flowability and compressive strength. Compared with the control, flow diameter decreased by 1.47% and 15.77%, while 28-day compressive strength decreased by 14.55% and 35.10% for PTW 0.5 and PTW 1, respectively. TGA results indicated that PTW did not exhibit pozzolanic activity, with calcium hydroxide (CH) content increasing from 7 to 28 days by 2.76% and 5.38% for PTW 0.5 and PTW 1, respectively. Bound water content increased by 11% in both mixtures over the same period. SEM revealed increased porosity and localized separation at the fiber–matrix interface, indicating a weak interfacial transition zone (ITZ), although calcium silicate hydrate (CSH) was observed on fiber surfaces by SEM and Raman mapping. The sustainability assessment showed limited greenhouse gas (GHG) emission reductions of 0.55% and 1.10% for PTW 0.5 and PTW 1, respectively, due to the small proportion of cement replaced by PTW. These limited emission reductions were offset by reductions in compressive strength, highlighting the need to improve mechanical performance.
No takes yet. Share an insight, caveat, or question.
Lea et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: