Answers are grounded in this paper and cite their sources.
Selective etching of AlxGa1−xN with x > 0.5, e.g., for the substrate lift-off of UVC emitters, is extremely challenging due to the very high bonding strength of the compound. Even electrochemical etching (ECE), which has proven very effective in AlxGa1−xN with lower x, leads to porosification rather than complete etching. We show here that by adding illumination during etching, i.e., photo-assisted electrochemical etching (P-ECE), complete etching can be achieved for x up to 65%. We studied the P-ECE of a range of sacrificial layers consisting of a highly Si-doped ([Si] = 3 × 1019 cm−3) multilayer AlGaN sacrificial layer of five periods of 5 nm AlxGa1−xN/5 nm AlyGa1−yN, with Al content (x/y) between (38%/48%) and (65%/75%) to lift-off Al0.76Ga0.24N membranes. The etching behavior was studied by varying the applied bias voltage, illumination intensity, and excitation wavelength of the photoexcitation source. The N-polar surface of a membrane grown on those multilayer sacrificial layers had a root-mean-square surface roughness between 5.9 and 7.8 nm, with a 5 × 5 μm2 scan size. By using a single 10 nm-thin sacrificial layer instead, we could obtain even smoother etched surfaces with a roughness of below 3 nm, comparable to that of the as-grown surface. We, thus, show that P-ECE is a promising technique for lifting off AlGaN membranes with high Al content and obtaining accurate control of the membrane thickness.
No takes yet. Share an insight, caveat, or question.
Nguyen et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: