Answers are grounded in this paper and cite their sources.
Geometric configuration influences the hydraulic performance, structural response, and material requirements of molten-salt risers in tower-based concentrated solar power plants. However, the effects of the principal geometric parameters on the hydraulic and structural responses of a complete riser system have not been sufficiently clarified. In this study, a full-scale molten-salt riser model was established under fixed total-height and lateral-space constraints. Thirteen configurations were generated using a single-factor parametric design, and computational fluid dynamics and structural finite-element simulations were employed to investigate the effects of the inclined-segment length-to-diameter ratio Ls/Di, elbow curvature ratio R/Di, and inclined-segment angle θ. The results show that increasing Ls/Di increases the overall system resistance coefficient but reduces the maximum von Mises equivalent stress under the combined load case by up to 17.12%. Increasing R/Di reduces both the overall system resistance coefficient and the combined-load maximum stress, while the maximum total deformation and pipe mass change only slightly. Increasing θ increases the overall system resistance coefficient but decreases the combined-load maximum total deformation, whereas the combined-load maximum stress varies nonmonotonically and reaches a minimum of 194.95 MPa at θ = 75°. These results clarify the distinct hydraulic and structural response trends associated with the three geometric parameters. Among the investigated configurations, the 45° configuration demonstrates a degree of coordination among hydraulic performance, structural response, and pipe material usage. The findings provide a numerical basis for the configuration design and parameter selection of molten-salt risers in tower-based concentrated solar power plants.
No takes yet. Share an insight, caveat, or question.
Liu et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: