Answers are grounded in this paper and cite their sources.
Commercial PCR thermal cyclers are expensive and need specialised maintenance and imported spare parts, which limits their use in teaching laboratories and small labs. This protocol describes how to build a prototype mini PCR thermal cycler from inexpensive, locally available components. An aluminium block (40 × 40 × 25 mm) with two tube wells is heated by a 220 V cartridge heater switched through a solid-state relay (SSR) and cooled by a 12 V fan driven by a TIP120 transistor. Block temperature is measured by a K-type thermocouple read through a MAX31855 amplifier. An Arduino Nano runs the cycling program (denaturation, annealing and extension) and shows temperature and stage on a 16×2 I²C LCD. The protocol covers parts, block preparation, wiring, programming, temperature calibration and a test PCR run. Heating, temperature control (PID with time-proportioned SSR switching) and automatic stage/cycle progression were tested successfully, with built-in safety cut-offs. Total component cost was about US$165 (self-funded). The fan-only cooling is the main limitation; adding a Peltier module is the next development step before validating DNA amplification. The device holds two 0.2 mL tubes and is intended as a proof of concept for teaching and low-resource settings, not for diagnostic use. _¹. Principle of PCR: 30–40 cycles of denaturation (~94 °C), primer annealing (~54 °C) and extension (~72 °C) (after Vierstraete, 1999)._ Build time: ~1–2 days, including epoxy curing. Cost: ~ US$165 in components.
No takes yet. Share an insight, caveat, or question.
shenekji et al. (2026) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: