Answers are grounded in this paper and cite their sources.
The stability of conducting polymer coatings on metallic substrates is often limited by poor interfacial adhesion, which can lead to delamination and degradation of electrochemical performance. Here, we report low‐impedance printed circuit board (PCB) electrodes based on electrodeposited poly(3,4‐ethylenedioxythiophene) (PEDOT) coatings on gold and electroless nickel–phosphorus (Ni–P) substrates. While PEDOT is widely used to reduce electrode impedance, poor adhesion on metallic substrates, particularly Ni–P, limits coating stability and long‐term performance. To address this limitation, we introduce an interfacial modification strategy based on EDOT‐acid pretreatment, which acts as a molecular adhesion promoter between the metal surface and the electrodeposited PEDOT film. X‐ray photoelectron spectroscopy (XPS) confirms the chemisorption of EDOT‐acid on both Au and Ni–P surfaces through carboxylate bonding and metal–sulfur interactions. Atomic force microscopy force–displacement measurements reveal a substantial increase in local surface adhesion after EDOT‐acid treatment, with adhesion forces increasing by approximately 2.5× on Au and nearly threefold on Ni–P substrates. Electrochemical measurements show that the PEDOT coatings significantly reduce electrode impedance and improve charge storage capacity. The EDOT‐acid pretreatment enables stable PEDOT coatings that remain intact after prolonged sonication, particularly on Ni–P, supporting its use as a cost‐effective alternative to gold.
No takes yet. Share an insight, caveat, or question.
Ebrahimi et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: