Answers are grounded in this paper and cite their sources.
Gravitational torque at manipulator joints persists even at rest and thus determines the continuous torque rating of the actuator. This study developed and validated a passive gravity-compensation joint wherein a cam plate extends a compression-spring link with an offset pin joint. Spring torque was derived by virtual work for an arbitrary cam profile, and the pitch curve was distinguished from the machined surface by a normal-offset correction omitted under the point-contact assumption. Because each harmonic coefficient of the Fourier-parameterized profile contributes to curvature with a weight proportional to the square of its order, raising the order trades curvature for accuracy: over the converged orders, the minimum curvature radius (the largest follower admitted without undercutting) fell by 20–34% while the residual fell 4.5- to 6.9-fold. Attainable accuracy was governed not by stiffness but by whether the springs can store the gravitational energy within their allowable stroke. A 5 kg prototype reduced the peak joint torque by 73.2% on the hysteresis-removed basis but by 20.8% in actuator demand, which includes friction. The measured spring torque matched the model within 5%; half the shortfall from simulation stemmed from a load 11% above design, and the gap between bases from sliding friction.
No takes yet. Share an insight, caveat, or question.
Lee et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: