Answers are grounded in this paper and cite their sources.
Drop casting is commonly used to screen non-Pt electrocatalysts, where the catalyst to be tested is applied to the disc part of an RDE/RRDE electrode as an ink. This approach is quick and straightforward but introduces inconsistencies due to differences in deposition protocol, ink composition, and testing conditions between different studies. This work systematically investigates the impact of three modifications to the drop casting procedure: the use of a heat lamp during drying, electrode rotation during drying, and the inclusion of IPA in the ink. A perovskite catalyst material, LaMnO 3 , was used for all tests and a commercially available 20% Pt/C was used as benchmarks for the ORR. Electrochemical ORR performance and catalyst distribution over the electrode were analysed with RRDE electrochemical measurements, large area EDS mapping and contact angle measurements. A unique large area EDS map enabled the distribution of catalyst material to be separated from the distribution of the supporting carbon, which is not possible with optical microscope images alone. Contact angle measurements confirmed that surface hydrophobicity is affected by alterations to the drop casting protocol with the use of a heat lamp, rotation and IPA all associated with higher contact angles reflecting poor electrode wettability. In the ORR measurements a lower calculated peroxide percentage was associated with a high contact angle. These findings highlight the importance of considering drop casting parameters when screening electrocatalysts to improve reproducibility, and the necessity of establishing a common policy to report details of the drop casting procedure in publications.
No takes yet. Share an insight, caveat, or question.
Watson et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: