Answers are grounded in this paper and cite their sources.
The use of industrial by-products as partial cement replacements offers an opportunity to reduce Portland cement consumption while maintaining or improving mortar performance. This study evaluated the effects of fly ash (FA) and cement kiln dust (CKD) on the mechanical properties and water absorption of cement-sand mortar. Initially, FA and CKD were investigated separately at cement replacement levels of 5%, 10%, and 15% by mass, with mechanical testing conducted after 7, 14, and 28 days of curing. Based on the first-stage results, a replacement level of 5% was selected for each material to guide the preparation of three combined mixtures: 2.5%CKD + 2.5%FA, 2.5%CKD + 5%FA, and 5% CKD + 2.5% FA. Performance was assessed using compressive, three-point flexural, splitting tensile strength, and water absorption tests. Among the investigated formulations, the mixture containing 2.5%CKD + 5%FA achieved the highest mean mechanical strengths at all testing ages. At 28 days, its compressive, flexural, and splitting tensile strengths exceeded the corresponding control values by 18.9%, 43.9%, and 84.6%, respectively. All combined mixtures exhibited higher mean splitting tensile strengths than the control at each age, although the increase for 5% CKD + 2.5% FA at 28 days was not statistically significant. The 2.5% CKD + 5% FA mixture also exhibited the lowest approximate water absorption, decreasing from 3.2% for the control to 1.8%, equivalent to a relative reduction of approximately 43.8%. These findings identify this formulation as the best-performing mixture within the investigated experimental range, without establishing CKD-FA synergy or quantifying environmental benefits.
No takes yet. Share an insight, caveat, or question.
Mardanlou et al. (2026) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: