Answers are grounded in this paper and cite their sources.
The tribological behavior of aluminium (Al) composites reinforced with rutile (TiO2) at varying temperatures was investigated. Rutile, a thermally stable mineral, enhances the frictional properties. Microstructural analysis using an optical microscope revealed a homogeneous structure without agglomeration. Chip morphology studies indicated the formation of continuous separation free chips. Scanning electron microscopy (SEM) images reveal distinct shear-induced layers within the Al-12% titanium dioxide (TiO2) composite, suggesting enhanced structural integrity. The hardness measure shows a 58.79 percent increase following the incorporation of rutile (TiO2). A steady decline in friction was observed with increasing TiO2 content. The Al-12% TiO2 composite exhibited a low variation in the friction coefficient (5%), suggesting good machinability. The Al-12% TiO2 composite entered the severe wear zone beyond 150°C, later than other compositions and exhibited a 58.82 percent reduction in wear loss compared to Al-4% TiO2. The low standard deviation in wear loss (20.49 mg) indicates a uniform failure. SEM analysis of the worn surfaces highlighted minimal grooves, galling, and metal flow. EDS results confirmed low sensitivity to temperature changes, with adhesion and metal flow identified as the primary failure mechanisms.
No takes yet. Share an insight, caveat, or question.
Kumar et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: