Answers are grounded in this paper and cite their sources.
Background Simulation-based training is central to dental education, yet existing models present significant ethical, logistical, and financial constraints. While animal-derived models offer high realism, they raise ethical concerns, whereas commercial phantom models often lack sufficient haptic fidelity. This study evaluated an in-house developed 3D-printed intraoral model for basic oral surgical suturing training in direct comparison with both commercial phantom and biological porcine jaw models under standardized educational conditions. Methods In this prospective observational within-subject study, 38 seventh-semester dental students completed standardized suturing exercises on three simulation models: a custom 3D-printed intraoral model, a commercial phantom model, and a biological porcine jaw model. All participants trained on each model under identical supervision conditions before performing an intraoral suture clinically. Students subsequently evaluated perceived learning support, perceived realism, instructional conditions, and relevance of simulation-based training using a study-specific 5-point Likert questionnaire. Statistical analysis included repeated-measures ANOVA with Bonferroni-adjusted post hoc tests and multiple linear regression. Results For perceived learning support, the biological model received the highest ratings (4.20 ± 0.42), followed by the 3D-printed (3.88 ± 0.62) and commercial models (3.70 ± 0.73); biological versus commercial difference reached significance (p = 0.004). Perceived realism showed a similar pattern (3.59 ± 0.76 vs. 3.30 ± 0.85 vs. 2.98 ± 0.91; p = 0.02). Instructional conditions were rated uniformly high (4.53–4.61) without significant differences. Increasing age predicted higher ratings (p < 0.001), while male participants rated slightly lower (p = 0.024). Conclusions The 3D-printed model demonstrated educational acceptability comparable to the biological model in key domains while significantly outperforming the commercial model. These findings supported implementation in the practical State Examination with potential for interdisciplinary expansion. 3D-printed models offer standardized, reproducible, ethically advantageous alternatives to animal-based or commercially limited training formats in dental education.
No takes yet. Share an insight, caveat, or question.
Vollmer et al. (2026) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: