Answers are grounded in this paper and cite their sources.
Infant body temperature stability is paramount, especially for preterm newborns unable to maintain their own thermal equilibrium. Here, we explore a Proportional-Integral-Derivative (PID) control algorithm implemented directly on a Nextion Human–Machine Interface (HMI) to regulate infant warmer temperature. Unlike typical systems where the microcontroller holds the major PID calculation and the HMI acts as a display only, this method integrates the PID logic into the HMI itself, with possible reductions of microcontroller load, minimization of communication delays, and hardware architecture simplification. Three trials at a constant setpoint of 37 °C with varying combinations of PID gains were used with a fixed experimental setup. Temperature response indicators like rise time, settling time, percent overshoot, and steady-state error were measured and compared. Results indicate that with gains of Kp = 1.50, Ki = 0.05, and Kd = 1.50, the system reached a steady state of 36.97 °C with just 2.16 % of an overshoot and a settling time of about 7 minutes and satisfied neonatal warmer requirements. The results confirm that PID control executed directly on the Nextion HMI can achieve temperature regulation performance comparable to conventional microcontroller-based implementations while improving system simplicity and code efficiency. It presents a good alternative choice of low-power and portable infant warmer and also of other embedded hot and cold control systems.
No takes yet. Share an insight, caveat, or question.
Ardiyanto et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: