Answers are grounded in this paper and cite their sources.
This study evaluated the effects of ultra-speed (US) sintering on the translucency and microstructure of yttria-gradient zirconia. Eighty specimens were prepared from two yttria-gradient zirconias (5 mol% yttria-stabilized incisal and 4 mol% yttria-stabilized cervical layers). Each layer underwent conventional (CS) or US sintering. Translucency ( TP 00 ) was measured spectrophotometrically (n = 10/group). Microstructure, grain size, and phase composition were analyzed using field-emission scanning electron microscopy (n = 4/group) and Rietveld refinement (n = 2/group). Translucency was analyzed using three-way ANOVA, and grain size using a generalized linear model (α = 0.05). Under CS, the incisal layer ( TP 00 : 8.01–8.12) was more translucent than the cervical layer (7.27–7.45), whereas this relationship was reversed after US sintering. This reversal reflected a significant reduction in TP 00 in the incisal layer (Δ TP 00 : 2.78–3.00), exceeding the translucency acceptability threshold, while cervical changes remained within the translucency perceptibility threshold. Residual pores were more evident in the incisal layer after US sintering, with grain size increasing from 1.13–1.14 to 2.94–2.98 µm. After US sintering, the yttria-rich t′ -phase fraction increased, whereas the t -phase fraction decreased in both layers. These findings provide further insight into the potential layer-specific response of yttria-gradient zirconias to US sintering.
No takes yet. Share an insight, caveat, or question.
Shin et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: