Answers are grounded in this paper and cite their sources.
Fine finishing of internal cylindrical surfaces requires advanced honing after conventional honing to achieve the desired surface finish. Although conventional honing removes initial surface irregularities, it cannot produce the ultra-fine surface finishes required for high-performance applications. Moreover, separate finishing setups increase processing time and alignment errors. To overcome these limitations, a spline shaft gear mechanism integrated tool combining conventional honing and advanced magnetorheological honing (MRH) was recently developed. However, its bulky construction and minimum finishing diameter of 96 mm limit its application to larger cylindrical components. Therefore, the present work proposes a novel in situ type MRH tool integrating conventional honing and advanced MRH within a single setup under a unified motion control system. The proposed tool incorporates a compact link-joint-based uniform expansion mechanism that adapts to internal cylindrical diameters ranging from 55 to 96 mm. An integrated bevel gear-based tool-holding fixture enables smooth switching between conventional honing and advanced MRH without workpiece repositioning. Finite element and dynamic analyses validated the tool design. Experimental results reduced the surface roughness of an EN-31 cylindrical workpiece from 6.12 μm to 0.047 μm. The proposed tool eliminates multiple setups, improves productivity and offers an industrially viable solution for precision finishing of internal cylindrical components.
No takes yet. Share an insight, caveat, or question.
Khatri et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: