Answers are grounded in this paper and cite their sources.
This study investigates the multi-response optimization of abrasive water jet machining (AWJM) of lowcarbon steel using grey relational analysis (GRA).A two-level full factorial design supplemented with three centre-point runs was employed, comprising eleven experiments.Water pressure, traverse speed, and stand-off distance were investigated within ranges of 270-310 MPa, 400-600 mm/min, and 3-5 mm, respectively.Material removal rate (MRR) and surface roughness (SR) were selected as performance responses, aiming to maximize MRR and minimize SR.The responses were normalized, and grey relational grades were calculated using equal response weights and a distinguishing coefficient of 0.5.Experiment 4 achieved the highest grey relational grade of 1.000 at 310 MPa, 600 mm/min, and 3 mm, producing the highest observed MRR of 25.57 and the lowest observed SR of 0.72 μm.Analysis of the mean grey relational grades identified A3B1C1, corresponding to 310 MPa, 400 mm/min, and 3 mm, as the preferred combination based on factor-level averages.Thus, A3B1C1 represents the combination selected from marginal means, while Experiment 4 remains the best observed experimental run.
No takes yet. Share an insight, caveat, or question.
Elsiti et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: