Answers are grounded in this paper and cite their sources.
This article proposes a hybrid concept for rapid tooling in investment casting for the impeller of the CH 100/32-15-1 sealed centrifugal pump, which overcomes the dimensional limitations of 3D printing and reduces tooling costs. The moulding elements of the discs are manufactured by turning, whilst the complex-shaped three-dimensional blades are produced using additive manufacturing methods. A comparison was carried out between eight configurations of polymer moulds (SLS using PA-12 and FDM using ABS with 0.2 and 0.4 mm nozzles, without post-processing, after mechanical polishing and smoothing with acetone vapour) and a reference industrial aluminium mould. The surface roughness of the working cavities was measured using a Form Talysurf Intra profilometer (12 traces per mould), whilst the geometry of the resulting wax patterns was checked using a Creaform HandyScan 700 Elite 3D scanner to analyse the hydraulic surfaces of the blades. The use of untreated PA-12 (Ra = 3.335 ± 0.358 µm) caused chipping of two out of five wax patterns during removal, whilst mechanical polishing reduced Ra to 0.157 ± 0.031 µm, surpassing the aluminium reference standard (0.247 ± 0.043 µm) in terms of roughness. The proportion of the blade area within the ±0.100 mm tolerance range was 86.1% for the aluminium mould and 12.4–53.9% for the polymer moulds (with the highest value for the polished PA-12), with a systematic positive deviation observed in all printed samples. Thus, polished SLS moulds made from PA-12 represent a cost-effective solution for prototyping and small-batch production of wax blade patterns, provided that warpage is taken into account.
No takes yet. Share an insight, caveat, or question.
Petco et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: