Answers are grounded in this paper and cite their sources.
Additive manufacturing enables the programmable placement of continuous carbon fibres, but integrating thermoset curing directly into the printing process remains challenging. We report an electrothermally assisted extrusion and curing (ETEC) method for supportless fabrication of continuous carbon fibre-reinforced thermoset composites. ETEC uses braided continuous carbon fibre as both the reinforcement and the resistive heater during coaxial extrusion of a thermoset resin. Joule heating within the continuous carbon fibre promotes resin spreading and capillary infiltration, while continued heating promotes crosslinking and stabilises the deposited filament. No external heaters or photoinitiators are needed. At a linear power density of 52.6 W m−1, the braided continuous carbon fibre reaches 175 °C within 15 s, and a stationary-droplet experiment shows resin uptake by the heated braid within approximately 6 s. The method enables continuous out-of-plane deposition from a supporting substrate and between spatially separated points. The printed composite filaments reach a fibre volume fraction of 57.8%. Compared with filaments printed without heating, processing at 175 °C nearly doubles the apparent interfacial strength, to 69.44 MPa, and increases the tensile strength 2.2-fold, to 753.51 MPa. ETEC thus enables supportless printing of high-fibre-content thermoset composites.
No takes yet. Share an insight, caveat, or question.
Yang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: