Answers are grounded in this paper and cite their sources.
Inconel® 690 (A690) is a Ni–Cr alloy currently used for structural components, including bubbler tubes, in Waste Treatment and Immobilization Plant (WTP) glass melters. These components are exposed to a range of corrosive environments, including the melter headspace, cold cap, and molten glass, with particularly severe degradation occurring at interfaces such as the glass melt-line. RA 602 CA® (A602) is another Ni–Cr alloy being considered as an alternative material for these applications. This study investigates the microstructural corrosion behavior of A690 across a range of simulated waste-glass compositions and compares its performance with A602 in three selected direct-feed high-level waste (DFHLW) glasses. Alloy coupons were exposed to molten glass in static crucible tests at 1150 °C for 7 days and subsequently characterized using optical microscopy, scanning electron microscopy coupled with energy-dispersive X-ray spectroscopy (SEM/EDS), scanning/transmission electron microscopy (S/TEM), and X-ray absorption spectroscopy. In DFHLW-02, DFHLW-11, and DFHLW-15, A602 exhibited lower dimensional material loss but deeper residual grain boundary attack (GBA) than A690, while neither alloy consistently outperformed the other when total corrosion depth was considered. Post-test microstructural characterization revealed Cr-rich oxide scales, subsurface Cr depletion, pore formation, intergranular oxidation, and secondary phases that varied with glass composition. In A602, Al-F- and Y-F-rich regions were observed alongside an Al-N-rich particle exhibiting diffraction characteristics consistent with wurtzite AlN. X-ray absorption near-edge structure (XANES) analysis revealed a higher Cr(VI) contribution in the recovered corrosion scale (~ 21%) than in the as-prepared and post-test LAWHNK-08 glasses (~ 8% and ~ 7%, respectively). These findings highlight the importance of evaluating alloy corrosion resistance using complementary measures of dimensional material loss, intergranular penetration, elemental redistribution, and secondary-phase formation rather than relying on a single corrosion metric.
No takes yet. Share an insight, caveat, or question.
Bryce et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: