Answers are grounded in this paper and cite their sources.
This study investigates the influence of machining environment—atmospheric versus submerged—on the performance of Abrasive Water Jet Machining (AWJM) of Nimonic-90, focusing on depth of penetration (DOP) and surface quality. Experiments were conducted using a Taguchi L27 design considering water pressure (WP), traverse speed (TS), abrasive flow rate (AFR), and stand-off distance (SOD) as control parameters. Atmospheric machining achieved a maximum DOP of 37.46 ± 3.01 mm at 275 MPa, whereas submerged machining produced smoother surfaces ( Rₐ = 1.91 – 4.45\, m) due to the damping effect of the surrounding water medium. TS was identified as the most influential parameter ( Δ = 6.36 ), with an increase from 50 to 150 mm/min reducing DOP by approximately 54.6%. The optimal parameter combination for maximum DOP was WP = 275 MPa, TS = 50 mm/min, AFR = 300 g/min, and SOD = 2 mm. The Hybrid Cohort Intelligence (HCI) model incorporating polynomial regression demonstrated strong predictive capability, achieving R² = 0.9812 and MSE = 1.106 for AWJM, and R² = 0.9900 and MSE = 0.520 for Submerged Abrasive Water Jet Machining (SAWJM). Overall, atmospheric AWJM is suitable for higher material removal, while SAWJM provides superior surface integrity, offering a useful framework for process optimisation of Nimonic-90 within the investigated parameter range.
No takes yet. Share an insight, caveat, or question.
G et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: