Answers are grounded in this paper and cite their sources.
Cable-driven robotic manipulators can reduce distal mass by relocating actuators proximally, but increasing the number of remotely actuated degrees of freedom (DoFs) introduces complex cable-routing coupling and challenges in integrating payload capability with dexterous manipulation. In this study, we present LYNX-10, a lightweight 10-DoF cable-driven manipulator comprising a six-DoF arm and a four-DoF gripper. The arm combines a tower-type lifting mechanism, a selective compliance assembly robot arm (SCARA)-type positioning module, and a three-DoF quasi-spherical wrist. The design combines an elbow cable-routing decoupling mechanism with a geometry-based quasi-static compensation model implemented in the controller to compensate for deterministic cable-length redistribution during joint motion. The proposed compensation model substantially suppressed parasitic yaw motion during elbow rotation and parasitic pitch motion during combined elbow and wrist-yaw rotation. Coordinate-wise end-effector repeatability remained below 0.4 mm ( \(3σ\) ) at three tested positions. The 6 kg manipulator assembly handled payloads of up to 6 kg within shoulder and elbow operating ranges that narrowed as the payload increased. The four-DoF gripper generated a mean sustained pinch force of approximately 30 N over five measurements and enabled a page-turning task through coordinated thumb–index-finger, wrist, and arm motion. These results demonstrate a compact cable-driven architecture combining load-carrying capability, geometric coupling compensation, and dexterous end-effector manipulation.
No takes yet. Share an insight, caveat, or question.
Zhu et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: