Answers are grounded in this paper and cite their sources.
The curing procedures of a chromium-free organic–inorganic coating solution were studied using thermogravimetry–differential scanning calorimetry (TG–DSC). Accordingly, the curing processes of the coatings on non-oriented silicon steel plates were designed and optimized. Each curing procedure was divided into drying and sintering stages. These stages were confirmed by two DSC extreme peaks at heating rates lower than 0.33°C/s. These peaks merged into one at higher heating rates. The curing completion temperatures (Tef) exhibited a positive linear relationship with the heating rate, allowing prediction of the curing temperature at given heating rates. Curing completion was the key factor affecting the coating performance. Incomplete curing resulted in low sheet resistance and low corrosion resistance due to the presence of residual conductive functional groups, as well as low adhesion of the coating to the steel plates. This resulted in low laminated bonding strength due to the low elastic modulus of the coatings. Moreover, over-aged coatings exhibited low laminated bonding strength due to their increased brittleness. The optimal curing process was obtained for the coated plate cured at a low temperature for a relatively long time (conditions: curing temperature = 293°C, curing time = 10.5 s, drying temperature = 476°C–499°C, sintering temperature = 311°C–325°C, heating rate = 7.58°C/s, and plate temperature = 301°C).
No takes yet. Share an insight, caveat, or question.
Li et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: