Answers are grounded in this paper and cite their sources.
This study investigates the flexural performance of ultra-high-performance concrete (UHPC) - reinforced concrete beams strengthened by carbon fiber reinforced polymer (CFRP) on the groove. Three concrete compressive strengths were employed to this end. Ten beam specimens were strengthened via CFRP using external bonded reinforcement on grooves (EBROG) and external bonded reinforcement (EBR), and tested under three-point loading to investigate the influence of differing concrete compressive strengths, and the presence of a UHPC layer at the tension face of the beam of different thicknesses (2 cm or 5 cm). In this study, the flexural capacity, deflection, crack behavior, and failure modes were examined. The beams were categorized according to the strengthening technique: EBROG, EBR, and a control beam specimen. The results showed a significant improvement in the flexural strength of RC beams strengthened with CFRP. The increase in load-carrying capacity was 51.6% for the beam strengthened via the EBR method and 90% for the beam strengthened via EBROG method, as compared to the control beam. In the same manner, the increase in load-carrying capacity was 120% and 140% for beams strengthened by CFRP using EBROG and where the concrete at the tension face was replaced with UHPC with thicknesses of 2 cm 5 cm, respectively. Increasing the compressive strength from 30 MPa to 45 MPa led to an increase in the load carrying capacity of 23.2%. The addition of transverse grooves to the longitudinal grooves in the EBROG method led an improved load-carrying capacity of 22%
No takes yet. Share an insight, caveat, or question.
Maid et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: