Answers are grounded in this paper and cite their sources.
There are serious biological concerns associated with excess cement following cementation. This study aimed to investigate the effects of different replica materials, fabrication methods, and vent hole designs on the amount of excess cement and pull-out strength. Sixty abutments with analogues were torqued and embedded in resin blocks. Metal crowns were fabricated via laser sintering with a 50 μm cement gap and a pull-out ring ( n = 10); ten crowns had vent holes. Six groups were tested: (1) control with conventional cementation, (2) resin-ceramic replicas via 3D printing, (3) bis-acryl replicas, (4) silicone replicas, (5) PMMA replicas via CAD/CAM milling, and (6) crowns with a vent hole. During trial cementation on replicas, excess cement was removed. The remaining cement on definitive abutments was collected and weighed. Pull-out tests were conducted, and data analyzed with one-way ANOVA and Tamhane’s T2 post-hoc tests. All experimental methods showed significantly less residual cement than the control ( P < .001). Excess cement amounts ranked from highest to lowest were: control, vent hole, silicone, bis-acryl, CAD/CAM milling, and 3D printing. Pull-out strength was significantly higher only in the bis-acryl group compared to the control group ( P < .001), while the CAD/CAM PMMA group showed significantly lower values ( P < .001). All tested methods reduced cervical cement compared to conventional cementation. Bis-acryl replicas provided a favorable balance between cement reduction and retention, whereas CAD/CAM-milled PMMA replicas significantly reduced crown retention.
No takes yet. Share an insight, caveat, or question.
Kutlu et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: