Answers are grounded in this paper and cite their sources.
This study examines how castor oil (CST), palm olein (PLM) and dioctyl adipate (DOA) affect the cure kinetics, processing window and network properties of a highly filled (79.87 wt% solids) AP/Al/HTPB/TDI propellant (NCO/OH = 0.94) relative to an unplasticized (UNP) baseline. Cure (ATR-FTIR) and slurry viscosity were followed at 50, 60 and 70 °C for two independent batches per system. Seven kinetic models were ranked by AICc and screened for parameter identifiability by residual bootstrap. The Kamal–Sourour autocatalytic constant was not identifiable; all parameters of a two-step second-order model were. The C = C band at 1620–1660 cm⁻¹, a common internal reference for HTPB, grew about 1.5-fold during cure relative to two independent bands, so results were checked with all three. Castor oil was the only plasticizer that accelerated the cure with every reference (k₁(60 °C) 16.1–17.7 versus 9.1–10.0 × 10⁻³ min⁻¹; t₅₀ 57–62 versus 100–110 min), consistent with its hydroxyl groups acting as co-curative. DOA and PLM cured no faster than UNP, and the late-stage cure of DOA slowed. All plasticizers lengthened the time to the 10⁴ P casting limit at 50 °C (UNP 68 min; CST 119, DOA 127, PLM 138 min), PLM giving the widest and least temperature-sensitive window. Diffusion control at high conversion remained unresolved. With network data for the same formulations (crosslink density 40–54% of UNP), the results show that cure rate, processing window and network structure respond differently to the plasticizer and must be characterized separately.
No takes yet. Share an insight, caveat, or question.
Pinalia et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: