Answers are grounded in this paper and cite their sources.
The consolidation of hard road concretes is a key technological operation in the construction of cement concrete bases and surfaces. Insufficient vibrational impact preserves porosity, while excessive or improperly distributed vibration disrupts the grain framework. In this regard, computational optimization of the operational and constructive parameters of the vibrating device, taking into account contact dynamics, is of great importance. The study objective is to numerically optimize the mass of the cantledge and the rotational speed of the vibration device drive with asymmetric excitation for consolidating the hard road concrete BSKD V30 Zh2 F200 W6. The calculation basis is a laboratory system based on GTL 2 device. The motion of the movable assembly is described by a one dimensional nonlinear contact model with unilateral interaction between the stamp and the mix. The asymmetric mode is represented by a three harmonic excitation (three stages of debalance), while the symmetric mode is represented only by the fundamental harmonic. Optimization is carried out using a grid enumeration within the range of the cantledge mass from 10 to 50 kg and the frequency of the small drive wheel from 300 to 1500 rpm. For the asymmetric mode, the optimal parameters are the following: cantledge mass of 30 kg, frequency of the small wheel of 1500 rpm (large wheel — 500 rpm). The integral quality criterion reached Qmax = 15.32, useful impulse Jpol = 61.64 N•s/cycle, peak reaction Rmax = 5168.06 N, and maximum pressure Pmax = 2067.2 kPa. For the symmetric mode, the optimum is obtained with the cantledge mass of 33.33 kg and the same frequency; Qmax = 12.84, Jₚₒₗ = 57.26 N•s/cycle, Rmax = 4697.18 N, Pmax = 1878.9 kPa. The advantage of the asymmetric mode in terms of Q is 19.31 %. The results show that polyharmonic excitation generates a more effective contact pulse mode due to the rational redistribution of dynamic impact over time, providing a greater useful impulse and more concentrated contact without increasing the cantledge mass. The calculated data can be used for the preliminary selection of test bench modes.
No takes yet. Share an insight, caveat, or question.
Lyubimyy et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: