Answers are grounded in this paper and cite their sources.
Fiber-reinforced polymer (FRP) systems are widely used to repair corroded steel pipes, but the required repair thickness depends strongly on the stiffness level of the FRP layer, particularly its hoop direction modulus. This study developed finite-element (FE)-based repair thickness maps for externally repaired corroded steel pipes using normalized FRP stiffness levels. An axisymmetric FE model was developed for a steel pipe containing a circumferentially continuous external corrosion groove of finite axial length, filled with epoxy and externally wrapped with an FRP layer. The model was verified against an analytical multilayer thick-cylinder solution based on Lamé theory. A parametric study was performed by varying the pipe's diameter-to-thickness ratio (D/t = 10, 20, 40), normalized defect depth (a/t = 0.10–0.60), and FRP-to-steel-stiffness ratio (EF/E = 0.20–1.20). For each configuration, the required normalized FRP thickness (tF/a) was determined using a 10 % stress tolerance criterion relative to the corresponding intact pipe. The results showed that increasing EF/E reduced the required tF/a, whereas deeper defects required larger normalized repair thicknesses. Several low-stiffness FRP systems exhibited indeterminate feasibility for deeper defects within the investigated thickness range. A compact empirical correlation was proposed to estimate tF/a, achieving R 2 = 0.90, MAE = 0.13, RMSE = 0.34, and MAPE = 7.36 %. Five-fold cross-validation showed comparable predictive performance for held-out cases, further supporting the robustness of the proposed correlation within the investigated parameter range. The developed maps and correlation provide a preliminary stiffness-based framework for FRP thickness selection.
No takes yet. Share an insight, caveat, or question.
Mustafa Alhusain (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: