Answers are grounded in this paper and cite their sources.
Direct air capture (DAC) requires sorbent contactors that can process large air volumes with minimal pressure drop while enabling rapid, energy‐efficient regeneration. A multiscale conductive honeycomb contactor based on nanoporous amorphous carbon (NAC) is presented, in which adsorption‐active porosity, mechanical support, electrical conduction, and Joule‐heat generation are integrated within the same continuous framework. The fully interconnected NAC pore network accommodates epoxide‐functionalized polyethyleneimine while preserving CO 2 ‐accessible transport pathways after binder‐assisted shaping into a mechanically robust monolith. Straight‐through honeycomb channels enable low‐resistance airflow with efficient CO 2 capture, whereas the conductive NAC walls act as volumetric heating elements positioned directly adjacent to the CO 2 ‐binding phase for fast regeneration. The optimized contactor achieves a volumetric adsorption productivity of up to 0.32 mmol cm −3 h −1 while maintaining a specific fan‐energy demand below 10 J m −3 . Direct Joule heating enables more than 95% desorption within 16 min under the laboratory N 2 ‐purge protocol, approximately twofold faster than external heating under the same conditions, with no measurable capacity loss over a 15‐cycle short‐term test. The key advance is the simultaneous integration of high volumetric capacity, accessible nanoporous transport, mechanical robustness, low‐resistance airflow, and electrothermal regeneration within a single honeycomb contactor.
No takes yet. Share an insight, caveat, or question.
Ji et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: