Answers are grounded in this paper and cite their sources.
The corrosion behavior of J55 wellbore steel containing pre-existing pits, machined crack-like grooves, and plastic bending deformation was investigated in field-collected geothermal water and an FeCl 3 -containing accelerated solution. Weight-loss measurements, three-dimensional surface profilometry, and finite-element simulations were combined to evaluate corrosion kinetics and defect evolution. In geothermal water, the average corrosion rate of each specimen series reached a maximum at 80 °C. Under accelerated conditions, bent specimens generally exhibited greater corrosion susceptibility, whereas the differences between pitted and grooved specimens were relatively small. Surface profilometry revealed that pits and grooves underwent predominantly lateral expansion rather than deepening. For pitting defects, local depth changes ranged from −1.2 to 3.5 μm, while mean width increases ranged from 4.75 to 16.5 μm. Negative depth changes indicate a reduction in measured depth relative to the surrounding reference surface. Qualitative simulations at 80 °C suggested that nonuniform species transport favored corrosion near defect openings, with an additional prescribed stress contribution in bent specimens. These findings provide insight into defect-dependent corrosion behavior relevant to geothermal well reuse, although the short-term experiments and simplified simulations do not permit long-term service-life predictions.
No takes yet. Share an insight, caveat, or question.
Zhengnan et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: