Answers are grounded in this paper and cite their sources.
Geopolymer concrete (GC) provides indispensable environmental advantages over conventional cement‐based concrete. However, attaining European Federation of National Associations Representing Concrete (EFNARC) standard self‐compacting properties in GC usually requires increasing activator and water content among other variations. Consequently, the self‐compacting GC (SCGC) typically yields poorer paste characteristics with reduced strength and enhanced water transport than commensurate GC. To address this issue, this study investigated the impact of substituting three supplementary cementitious materials (SCM): metakaolin, alccofine, and silica fume at 10% and 20% levels, on slump flow, setting times, compressive strength (CS), water absorption, initial surface absorption (ISA), acid attack resistance, and electrical resistivity ( ρ ) of fly ash–GGBS‐based SCGC. Results indicate that while metakaolin and silica fume reduced slump flow and setting times by up to 20%, alccofine inclusion induced flash setting behavior in SCGC, thus limiting its practical pertinence. In contrast, metakaolin and alccofine substitution improved CS by up to 66.9% and 46%, while silica fume remained relatively ineffective. Furthermore, metakaolin substitution performed best for improving paste characteristics by lowering water absorption, ISA and acid attack mass loss by up to 61.8%, 73.3%, and 68.5%, respectively, followed by alccofine and silica fume. Lastly, microstructural analyses confirmed distinctions in phases among metakaolin, alccofine, and silica fume substituted mixes, justifying their discrete roles in SCGC. To conclude, across the tested SCMs, 20% metakaolin substitution surfaces as the best measure to improve the durability of SCGC.
No takes yet. Share an insight, caveat, or question.
Singh et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: