Answers are grounded in this paper and cite their sources.
Automated RF amplifier sizing is challenging because the design process is inherently hierarchical, the parameter space is high-dimensional and strongly coupled, and high-fidelity circuit simulation is expensive. Conventional optimization and reinforcement learning methods typically require many iterations and make limited use of RF domain knowledge, making them costly under tight simulation budgets. Large language models (LLMs) provide broad prior knowledge and reasoning capabilities, but are unreliable for direct numerical optimization. This paper presents RFAmpDesigner, a two-level optimization framework for automated schematic-level sizing of differential CMOS RF amplifiers. At the outer level, the circuit-parameter space is abstracted into a resource-allocation space, where LLMs make high-level allocation decisions and adjust them according to feedback from the inner level. At the inner level, RF design knowledge is used to decompose the flat sizing problem into a sequence of low-dimensional subproblems. Conventional optimizers then solve these subproblems to find circuit implementations consistent with the assigned resources. This structure allows numerical optimizers to focus on low-dimensional searches in the circuit-parameter space, while the LLM reasons and acts over a physically meaningful design space using simulation feedback. The main evaluation covers low-noise amplifier (LNA), driver amplifier (DA), and power amplifier (PA) designs within the target differential CMOS RF amplifier family. Experimental results show that it achieves a higher success rate under a limited simulation budget in both easy and hard regimes.
No takes yet. Share an insight, caveat, or question.
Lu et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: