Answers are grounded in this paper and cite their sources.
Mineral liberation for flotation is inherently a three-dimensional (3D) surface property, yet it is conventionally quantified using sectional measurements from SEM (X-ray back-scattering, inherently 2D) based Mineral Liberation Analysis (MLA). This dimensional mismatch has rarely been critically examined. Here, we explicitly contrast the volumetric resolving capability of X-ray computed tomography (XCT) with the intrinsic 2D nature of SEM backscattered imaging to reassess liberation in flotation of coarse and composite sulphides. A bornite-rich ore was separated into two coarse fractions (–300+212 µm and –212+150 µm) and floated in a Hallimond tube. Feed and products were characterised by both MLA and XCT. While MLA quantified 2D areal sulphide fractions from polished sections, XCT reconstructed full particle volumes and directly measured exposed sulphide surface area, which is the physically relevant attribute controlling bubble–particle attachment. MLA systematically overestimated high-grade classes due to stereological bias, misclassifying composite particles with limited external exposure as liberated. In contrast, XCT revealed a threshold-controlled flotation response: particles with <25% exposed sulphide contributed negligibly to recovery, whereas those >65% behaved as effectively liberated. Flotation rate constants correlated strongly with 3D surface exposure but were dispersed when expressed as 2D sectional grades. These results demonstrate that liberation is fundamentally a 3D surface accessibility problem and that XCT-derived surface exposure provides a physically consistent descriptor of coarse composite particle flotation, exposing the inherent dimensional limitation of traditional 2D MLA metrics.
No takes yet. Share an insight, caveat, or question.
Dao et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: