Answers are grounded in this paper and cite their sources.
Integral abutment jointless bridges (IAJBs) eliminate expansion joints and bearings and are therefore attractive for mountainous regions; however, when such bridges are built on sloping terrain, the abutment–pile system is subjected to asymmetric soil restraint, the so-called slope effect, which complicates the soil–abutment–pile interaction (SAPI). This paper reports pseudo-static cyclic tests on a reduced-scale (1:3.23) integral abutment–reinforced concrete (RC) pile specimen embedded in a layered clay–sand profile, in which the slope effect was introduced by excavating the soil in front of the abutment, with the key parameter being the ratio b/d of the horizontal distance from the pile side to the slope crest to the pile diameter. Two configurations were tested on the same specimen and soil bed: APSD-1 on level ground, for which no slope crest exists and b/d → ∞, and APSD-2 on a 30° slope with b/d = 2.0. Within the common displacement range of ±1 to ±6 mm, the slope effect reduced the lateral force in the slope-facing direction by 24.9% at 6 mm and by 20.1% on average (average force ratio ξF = 0.799), reduced the secant stiffness at 6 mm by 24.9% and the initial secant stiffness by 11.8%, and reduced the average soil reaction on the pile to 0.932 times that of the level-ground case, whereas the equivalent viscous damping ratio in the slope-facing direction decreased by only about 5%. APSD-2, which was loaded to failure, exhibited a strongly asymmetric response: the skeleton curve in the slope-facing direction remained essentially elastic up to 35 mm, whereas the backslope direction showed elastic, elastic–plastic, hardening and descending branches, and the peak lateral force in the backslope direction exceeded that in the slope-facing direction by 646.3% (a ratio of 7.46). A plastic hinge formed at the abutment–pile joint, and the depth of the maximum soil reaction moved from 0.25 m (1.6 d) in the backslope direction to 0.65 m (4.2 d) in the slope-facing direction. Because a single specimen, a single slope angle and a single b/d value were examined, and because the two configurations were tested in sequence on the same specimen, the results are reported as observations on the tested model rather than as generalised design values; their implications for practice and the need for dynamic verification are discussed.
No takes yet. Share an insight, caveat, or question.
Luo et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: