Answers are grounded in this paper and cite their sources.
Reusable hydrocarbon adsorption requires sorbents that retain useful performance during repeated adsorption–recovery operation, rather than only showing high initial uptake. In this work, the cyclic adsorption and mechanical recovery performance of ZnFe 2 O 4 /stearic acid-coated melamine sponge (MS@ZnFe 2 O 4 @SA) was evaluated toward crude oil, n-heptane, and toluene, using stearic acid-coated melamine sponge (MS@SA) as the corresponding reference control. Adsorption capacity (Q), recovery efficiency (R), and water contact angle (WCA) were monitored over five consecutive adsorption–squeezing cycles. The results showed that reusable performance was strongly governed by hydrocarbon type. Crude oil exhibited the greatest sensitivity to sorbent modification, whereas n-heptane and toluene showed more moderate differences. Although MS@SA showed higher first-cycle crude-oil uptake, MS@ZnFe 2 O 4 @SA retained a substantially higher final-cycle adsorption capacity, indicating that ZnFe 2 O 4 reinforcement mainly preserved adsorption performance during reuse. The composite sponge also maintained higher adsorption capacities for n-heptane and toluene, but the improvement was less pronounced. Recovery efficiency increased after the first cycle and remained high during subsequent reuse, with MS@ZnFe 2 O 4 @SA showing consistently high recovery across all three hydrocarbons. These findings highlight that hydrocarbon identity and adsorption-capacity retention, rather than first-cycle uptake alone, should be considered when assessing the practical reuse of modified sponge sorbents.
No takes yet. Share an insight, caveat, or question.
Kutenaei et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: