Answers are grounded in this paper and cite their sources.
Subzero additive manufacture enables the fabrication of soft biopolymeric 3D scaffolds without chemical modification. However, most approaches typically employ large substrate undercoolings to promote rapid solidification, creating distinct boundary interfaces that can compromise structural integrity and control over scaffold microarchitecture. Here, we present a physics‐informed low‐undercooling strategy that utilizes solidification within a mushy state, enhancing interlayer continuity while preserving macroshape fidelity. Thermal modeling guided the development of a cooling protocol implemented on a modified commercial printer to manufacture collagen and hydroxyapatite‐loaded gelatin constructs, representing fibrous and mineralized musculoskeletal tissues. Electron microscopy and X‐ray computed tomography revealed monolithic, fabrication‐interface‐free scaffolds with highly interconnected microporous networks (>99% z ‐connected pore fraction), hierarchical pore‐size gradients, and vertically aligned pores antiparallel to the primary heat flow direction. Mechanical testing showed that material composition mainly controlled compressive behavior, whereas print architecture more significantly influenced tensile performance. Concentric infill architectures increased the linear tensile modulus of collagen scaffolds by ∼70% compared with conventional rectilinear architectures, without affecting failure strain, consistent with improved interlayer bonding and load transfer. This low‐undercooling cryoprinting strategy overcomes a key limitation by eliminating weak interlayer interfaces through controlled solidification, while displaying tunability of mechanical performance through architectural control for biomimetic musculoskeletal tissue engineering.
No takes yet. Share an insight, caveat, or question.
Baker‐Jones et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: