Answers are grounded in this paper and cite their sources.
This study aims to elucidate the heat and mass transfer mechanisms, quality changes, and drying state prediction during deep-bed hot air drying of wheat. The experiment was conducted to examine the effects of hot air temperature (50, 60, and 70 °C), bed thickness (10, 20, 30, and 40 cm), and initial moisture content (30.21% and 38.99%, dry basis) on the drying kinetics and quality of wheat. A moisture content prediction model was developed based on a GA–BP neural network. Increasing the hot air temperature significantly shortens the drying time of wheat. However, the hot air temperature of 70 °C caused a decrease in wheat brightness (L value) and pronounced deterioration in wet gluten content, bulk density, and sedimentation value. Hot air temperatures of 50 °C and 60 °C were found to provide the optimal balance between drying efficiency and quality preservation. A vertical moisture gradient was induced by bed thickness, and the grain bed thickness should be controlled at 30 cm or less. The Modified Henderson and Pabis model provided the best fit to the drying data (R2 ≥ 0.9995). At the same drying air temperature, the material with an initial moisture content of 38.99% exhibited lower effective moisture diffusivity and higher apparent activation energy (41.071 kJ/mol) than the material with an initial moisture content of 30.21%. The high-moisture-content material exhibited less deterioration in protein and color than the low-moisture-content material. The GA–BP neural network model of moisture content achieved R2 values ranging from 0.8915 to 0.9397, showing potential for state monitoring and intelligent control of the drying process. This study provides theoretical support for drying process optimization and equipment design.
No takes yet. Share an insight, caveat, or question.
Sun et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: