Answers are grounded in this paper and cite their sources.
Pt-Sn catalysts for propane dehydrogenation (PDH) have been widely studied in powder form; however, the combined effects of binder type and content on the shapeability, structural integrity, and catalytic behavior of extruded Pt-Sn catalysts for PDH remain largely unexplored. Commercial γ-Al2O3 and hydrotalcite-derived Mg(Al)O pellets were compared with hydrotalcite-rich extruded bodies formulated using boehmite-derived alumina or sepiolite binders. The results revealed that binder selection affected extrusion feasibility, pore architecture, mechanical strength (crushing strengths of 3.0–15.0 N/mm for the selected extrudates), and the radial distribution of the metal phase. Among the investigated systems, the hydrotalcite-derived Mg(Al)O reference exhibited the most favorable PDH performance (~30% propane conversion, close to equilibrium, with an apparent ~4% activity loss over 12 h), while the γ-Al2O3-supported catalyst showed the lowest propane conversion and selectivity. The extruded composites delivered intermediate performance, and increasing the boehmite content from 10 to 30 wt.% increased the coking rate fivefold. Notably, the hydrotalcite–sepiolite catalyst maintained stable conversion and ~94% propylene selectivity despite a higher coking rate, which TEM-EDX associated with coke deposition on the support rather than on the Pt-Sn particles. Overall, binder selection is a key factor controlling the structural, mechanical, and catalytic properties of extruded Pt-Sn catalyst bodies and reveals a trade-off between mechanical integrity and catalytic performance.
No takes yet. Share an insight, caveat, or question.
Ökten et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: