Answers are grounded in this paper and cite their sources.
Manufacturing perovskite photovoltaics over large areas requires a coating and conversion sequence that remains effective as the substrate width increases. Here, a blade-coated lead iodide intermediate containing N-methyl-2-pyrrolidone (NMP) and dimethyl sulfoxide (DMSO) was thermally restructured into a porous PbI2–NMP scaffold before immersion in a formamidinium iodide/methylammonium chloride solution. The blade gap and substrate translation speed were fixed at 150 μm and 20 cm min−1, respectively, while the post-coating heating time at 60 °C was varied from 0 to 10 min. X-ray diffraction of reference solvent-complex films suggests that mild heating preferentially removes the DMSO-associated fraction while the NMP-coordinated intermediate is retained, thereby opening infiltration pathways through the precursor layer. A 5 min treatment produced the most favorable balance between scaffold opening and suppression of crystalline PbI2, yielding larger perovskite grains and a time-resolved photoluminescence lifetime of 1224 ns, 2.8 times that of the unheated reference. Devices manufactured with this process achieved champion power conversion efficiencies of 25.40%, 23.25%, 22.08%, and 21.09% at device areas of 0.0803, 1, 25, and 64 cm2, respectively. These results identify intermediate-layer restructuring as a practical process-control step for transferring blade-coated perovskite fabrication from laboratory cells to larger photovoltaic modules.
No takes yet. Share an insight, caveat, or question.
Choi et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: