Answers are grounded in this paper and cite their sources.
Fabrication of a ZK60 (Mg-Zn-Zr) magnesium alloy using electron-beam additive manufacturing (EBAM) is an exceptionally challenging task due to the low boiling point of Mg, high thermal stress, solidification cracking, and some physical limitations of the raw material. Here, for the first time, a thin-wall ZK60 alloy was successfully produced using the EBAM approach. The electron-beam processing was performed by utilizing a single-pass scanning strategy and exponential reduction in heat input. The initial ZK60 wire had a sharp <0002> texture and exhibited a two-phase mixture: α-Mg(Zn, Zr) + MgZn2 Laves phase. The as-printed ZK60 alloy, according to the comprehensive SEM/EDS, XRD, and TEM analysis, was characterized by a eutectic microstructure, including fine-crystalline (~11.6 ± 2.7 μm) α-grains and MgZn2 particles segregated along the grain boundaries, as well as a minor fraction of Mg51Zn20 particles, identified by TEM. Within the narrow transition zone that is adjacent to the substrate, additional segregations of Zn-Zr intermetallic compounds were revealed only by SEM. The upper welded layer of the wall, according to the XRD analysis, exhibited indirect evidence of anisotropic grain growth along the <01–12> direction, perpendicular to the building direction. The grain structure was rich in dislocation-related defects. The gradients of mechanical stresses of the second kind were found in the matrix α-phase, which was also evidenced by a high microstrain level (0.05–0.07%). The EBAMed alloy had a yield strength of ~149 MPa, an ultimate tensile strength of ~282–290 MPa, and an elongation of ~23–28%.
No takes yet. Share an insight, caveat, or question.
Utyaganova et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: