Answers are grounded in this paper and cite their sources.
This study investigated the effects of filtered seawater and ground granulated blast-furnace slag (GGBFS) on the flowability, time-dependent rheology, setting behavior, and compressive strength of cement pastes. In Series I, the water-to-binder ratio (W/B) of ordinary Portland cement (OPC) pastes was varied from 0.30 to 0.60 to compare tap water with filtered seawater. In Series II, W/B was fixed at 0.30 and GGBFS replaced 0–60% of the OPC. Filtered seawater slightly reduced the initial flow at W/B values of 0.30 and 0.40 and accelerated the development of Bingham yield stress with elapsed time at W/B = 0.30. Rheological changes with GGBFS replacement were nonlinear, and the replacement level associated with the greatest structural build-up depended on the mixing water. Filtered seawater shortened both initial and final setting times at every W/B and GGBFS replacement level, although it did not fully offset the retardation caused by high GGBFS contents. It also increased the 1-day strength of the OPC paste; however, the corresponding gains for SP45 and SP60 were limited to 0.35 and 0.18 MPa, respectively, relative to the tap-water mixtures. The highest 28-day strengths were 52.24 MPa for SP30 with tap water and 53.63 MPa for SP15 with filtered seawater, while seawater-mixed SP45 and SP60 achieved 48.92 and 47.09 MPa, respectively. X-ray fluorescence analysis showed higher Na2O and Cl contents in the filtered-seawater mixtures. Increasing GGBFS replacement raised the MgO, Al2O3, and SiO2 contents and lowered the CaO and Fe2O3 contents. These results indicate that filtered seawater can partially mitigate the setting delay of GGBFS-blended pastes and support their 28-day strength development, but it does not remove the early-age limitations of high-volume GGBFS mixtures.
No takes yet. Share an insight, caveat, or question.
Seo et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: