Answers are grounded in this paper and cite their sources.
In this work, KH560 (3-Glycidoxypropyltrimethoxysilane) and KH550 (3-Aminopropyltriethoxysilane) were used to simultaneously modify hollow glass microspheres (HGMs) with three median particle sizes (D1 = 4.71 μm, D2 = 15.81 μm, D3 = 28.37 μm). HGM/SPGE (Sorbitol polyglycidyl ether) and mHGM/SPGE composites were then prepared. FTIR and XPS results confirmed that the silane coupling agents were grafted onto the HGM surface via Si-O-Si bonds and introduced epoxy and amino groups. After modification, the dispersion and interfacial bonding of HGMs in the SPGE matrix were significantly improved. Tensile tests showed that mHGMs with D1 exhibited the best modification effect. At 1.5% loading, the tensile strength reached 65 MPa. This value represented an increase of 29.5% compared with the unmodified system. At 2% loading, the tensile strength was 55.63 MPa. This value represented an increase of 22% compared with the unmodified system. D2 and D3 showed no clear trend in mechanical properties because of their small specific surface areas and limited grafting amounts. The introduction of HGMs reduced the dielectric constant and dielectric loss angle of the composites. After modification, interfacial polarization was suppressed. The dielectric properties were further improved. Infrared thermal imaging showed that mHGM/SPGE retained more regions at low temperature during 60 s of heating. Its thermal insulation performance during the first 60 s of heating was better than that of the unmodified system.
No takes yet. Share an insight, caveat, or question.
Wang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: