Answers are grounded in this paper and cite their sources.
Purpose To compare the biomechanical pull‐through strength of high‐tensile‐strength suture tape versus high‐tensile‐strength conventional suture in anterior and posterior glenoid labral repairs assessed by load‐to‐failure (N) testing in a cadaveric model. Methods Anterior labral tears were created in 10 matched pairs of fresh‐frozen cadaveric scapulae, and posterior labral tears were made in 10 additional matched pairs. For each pair, 1 scapula was randomly assigned to be repaired with a suture tape, whereas the contralateral scapula was repaired with a conventional suture. Transosseous tunnels were drilled, and the suture tails were passed through the tunnels. The specimens were then loaded to failure at a positive displacement rate of 6.5 mm/min. The force at which the suture pulled through the labral tissue (measured in Newtons) and the mode of repair failure were recorded. Results Seven specimens were included in the final analysis for anterior repairs. In anterior labral repairs, suture tape exhibited a higher load to failure (312.4 ± 100.1 N) than conventional suture (250.1 ± 87.5 N), although the difference did not reach significance ( P = .054). Ten specimens were included in the final analysis for posterior repairs. In posterior labral repairs, suture tape had a significantly higher load to failure (303.0 ± 82.6 N) than conventional suture (237.0 ± 69.3 N), with a 65.9‐N difference ( P = .046). All 14 repairs failed at the level of the tissue in anterior repairs. In posterior repairs, all 10 suture tapes and 6 conventional sutures failed at the tissue. Four posterior repairs using conventional suture failed at the level of the suture. Conclusions In this study, suture tape showed higher pull‐through strength than conventional suture in posterior glenoid labral repairs in this time‐zero cadaveric biomechanical model using transosseous tunnel repair with tied knots. Clinical Relevance Understanding the differences in strength can allow surgeons to optimize the suture selection in glenoid labral repair and potentially reduce the incidence of repair failures at the suture‐labrum interface.
No takes yet. Share an insight, caveat, or question.
Drake et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: