Answers are grounded in this paper and cite their sources.
Magnesium oxysulfate (MOS) cement has potential for lightweight and fire-resistant applications owing to its relatively low raw-material calcination temperature and favorable fire resistance. However, slow early strength development and insufficient water resistance restrict its wider use. To address these limitations, a seed suspension rich in 5Mg(OH)2·MgSO4·7H2O (5·1·7 phase), with a median particle size (D50) of 165 nm, was prepared by wet grinding and incorporated at dosages of 0–8%. Setting time, compressive strength, and strength retention after water immersion were evaluated, while isothermal calorimetry, Krstulovic–Dabic kinetic modeling, XRD, SEM, and MIP were used to characterize hydration and microstructure. Seed addition shortened setting time and improved compressive strength and softening coefficients. At the highest tested dosage (8%), the 1 d and 28 d compressive strengths reached 8.08 and 23.02 MPa, increases of 98.04% and 14.93% over the control, respectively. After 28 d of curing, softening coefficients following 7 and 28 d of immersion increased from 0.54 and 0.59 to 0.82 and 0.84, respectively. Seed addition shifted the main calorimetric peak to earlier times and generally increased the apparent kinetic parameters. XRD and SEM revealed stronger 5·1·7 reflections and denser interlocking of needle- and rod-like hydrates. At 8%, the MIP modal equivalent pore diameter decreased from 188.15 to 110.26 nm, while the relative fraction of pores above 200 nm decreased from 32.51% to 19.22%. These findings associate improvements in compressive strength and strength retention after immersion with changes in hydration behavior and microstructure.
No takes yet. Share an insight, caveat, or question.
Ai et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: