Answers are grounded in this paper and cite their sources.
Compared with traditional laser cladding, high-speed laser cladding offers higher coating deposition efficiency and a smaller heat-affected zone. However, the causes of melt-pool asymmetry on the substrate surface and their effects on the substrate microstructure and mechanical properties remain unclear. This study focuses on Q345 steel and Inconel 625 powder, aiming to elucidate how process parameters influence melt pool behavior and how coating formation affects the substrate microstructure and mechanical properties. The results showed that melt-pool width and depth increased with increasing laser power but decreased with increasing laser scanning speed. Increasing the powder feed rate increased coating height and width while reducing the dimensions of the remelted region in the substrate. Melt-pool asymmetry arose from nonuniform powder flow and disturbed laser-powder interactions, whereas the lack of temporal synchronization among the three laser beams had a negligible effect on this asymmetry. In the multi-track coating, iron segregated mainly in the overlap regions between adjacent tracks and overlap higher than 65% promoted lack-of-fusion porosity. The coating exhibited coarse epitaxial columnar grains, a strong <001> texture, and predominantly recrystallized or recovered structures with low lattice distortion. The Inconel 625 coating significantly enhanced the tensile strength of the Q345 substrate. Compared with uncoated Q345 steel, the coated specimens tested parallel and perpendicular to the laser-scanning direction exhibited increases in ultimate tensile strength of approximately 118 and 137 MPa, respectively.
No takes yet. Share an insight, caveat, or question.
Zhong et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: