Answers are grounded in this paper and cite their sources.
This paper presents a damping-informed simulation-based optimization procedure for two-gain active suspension controllers with actuator saturation. An actuator-augmented nominal model screens spectral stability and oscillatory damping, while a nonlinear half-car model evaluates body-motion performance with nonlinear suspension forces, command saturation, and first-order actuator dynamics. The contribution is an auditable separation of these computational roles rather than a new optimizer or pole-placement theorem. The revised study verifies every reported gain with a structure-consistent output matrix and a final modal acceptance check. Quantitative post-disturbance metrics show that a damping reference of 0.3 substantially reduces residual acceleration, pitch-rate response, and actuator activity relative to zero-reference designs, although deterministic peak responses can increase. A conventional LQ-SOF baseline remains competitive under deterministic excitation, whereas the damping-informed controllers generally reduce actuator activity and improve transfer behavior; the SOF-M reference-0.3 controller also improves both ISO body-motion RMS measures relative to its LQ-SOF counterpart. A full objective-scaling factor and damping-reference sensitivity study identifies 0.3 as an intermediate damping requirement, and independent-road one-factor-at-a-time (OFAT) tests show that the pitch-suppression benefit is retained under moderate mass, suspension-damping, and actuator-bandwidth variations. However, heave acceleration RMS, dynamic tire load, suspension stroke, and high-speed actuator saturation exhibit trade-offs. The results therefore support damping screening as a practical means of excluding low-decay, high-activity candidates, not as a guarantee of uniform nonlinear performance.
No takes yet. Share an insight, caveat, or question.
진태석 et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: