Answers are grounded in this paper and cite their sources.
Background Use of open sources in nuclear medicine facilities demands reliable surface contamination measurements. Regulatory limits for contaminated areas are set at very low surface activity values, from 0.4 Bq cm -2 to 4 Bq cm -2 . Objective This study evaluates the sensitivity of two different contamination meters to detect low contamination values in clinical settings using radionuclides with different decay modes. Additionally, the effect of contaminated area size on sensitivity and quantitative accuracy was assessed. Methods Two types of contamination meters were used to measure four radionuclides with different decay modes: 223 Ra, 177 Lu, 99m Tc, and 18 F. The measurements were performed at two different distances (2 cm and 10 cm) and over two surface areas (1 cm 2 and 16 cm 2 ). Results At a 2 cm distance and 16 cm 2 surface area, the lowest detectable surface activity was 2 Bq cm -2 for alpha- and beta-emitting radionuclides, whereas for 99m Tc it was above 1 kBq cm -2 . Quantitative accuracy was the highest for 177 Lu with surface activity between 5.0–12.5 Bq cm -2 , ranging from 1.1% to 20.9%. For the smaller surface area (1 cm 2 ), detection limits were substantially higher: 1 MBq cm -2 for 99m Tc and 40 Bq cm -2 for 223 Ra, 177 Lu, and 18 F. Conclusion Measurement sensitivity and accuracy depend strongly on radionuclide decay mode and contaminated area size. Small, concentrated contaminations are detectable only at sufficiently high surface activity whereas lower surface activity values become detectable when the size of the contaminated area increases. Importantly, contamination meters demonstrated optimal performance for alpha and beta emitters, which represent the most significant contamination risk in clinical practice.
No takes yet. Share an insight, caveat, or question.
Hakulinen et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: